Sachtler introduces the Artemis EFP HD SE camera stabilizing system, designed to work with the RED ONE camera. The EFP HD SE was designed and engineered in Germany, following the same philosophy as the entire Artemis stabilizing line.

	Sachtler Artemis EFP HD SE with RED ONE

Two key features of the system are the 15 amp high-capacity camera power supply and new Hot Swap technology. These features make the Artemis EFP HD SE well suited for use with the RED ONE and similar HD cameras.

In addition to the standard 3-pin camera power out, 3-pin aux power and 4-pin focus power out sockets, there is an extra new camera power-out, using the same Lemo 2B 6-pin socket and wiring scheme as the RED ONE. The new HiCap high capacity power supply allows the Artemis EFP HD SE to handle 14V, 15A at 210W without any problem.

When the Artemis EFP HD SE system is used with 14V and up to 11A/154W, the voltage drop is less than 4 percent. When shooting with the RED ONE camera using the Red Brick 140WH battery pack, the operator is guaranteed maximum run time and optimum battery capacity. The voltage drop of this combination is less than 4 percent. Plus, battery capacity data is displayed in the eyepiece of the RED ONE when a Red Brick or other battery supporting capacity data is used.

Due to the modularity of the Artemis EFP HD SE, the use of the 5'3" super post with an HD camera stabilizer system is no longer a problem, allowing unusual perspectives to be achieved. The patented "dual dynamic balance" of Artemis systems allows mounting of two batteries at four independently adjustable positions. This feature offers two benefits: more than enough battery power on board, and flexible positioning of the batteries for perfect dynamic balance.

According to Curt O. Schaller, inventor of the Artemis, the new HiCap wiring, the use of new power-out sockets, and Hot Swap technology, in combination with HQ HD-SDI video, are logical steps into the future of digital cinematography camera support.

The Artemis EFP HD SE provides camera power Hot Swap technology made by Anton/Bauer. Users are free to change the batteries of the rig without rebooting the camera. The special circuit made by Anton/Bauer ensures easy and problem-free hot swap procedures, and is friendly to the batteries. Regardless of the camera used, this Hot Swap capability can save valuable production time.

The system supports HD-SDI video processing up to 4.5 GHz. The HQ HD-SDI video line allows the use of the Transvideo CineMonitor HD 6" SBL. With a built-in waveform monitor, a digital bubble and free adjustable frame-lines, the operator has maximum control.

The Artemis EFP HD SE system includes the ACT 2 vest and ACT 2 spring arm. The ACT 2 vest features seven segments that are freely positionable to provide the ideal fit for the operator's shoulder, chest and hip areas.

"Decades of experience and close working relationships with operators have helped us optimize carrying comfort at the body's most sensitive load-bearing points," explains Schaller. The ACT 2 vest's optimized fit contributes greatly to improved operation of the system and operator comfort.

The lightweight ACT 2 arm enables quick, precise and soft operation. Advanced aeronautical technologies and solutions were incorporated in developing the arm, providing load capacities of 22.6 - 53.3 lb. (11 - 26 kg). The new turnover mechanism of the mating block can be adapted to the preferred operating side quickly and safely. In addition, the mating block is 3mm higher than in previous versions allowing a steeper angle adjustment. Despite this modification, the arm still fits into vests of other manufacturers and offers more adjustment possibilities including modifying the angle between the arm and the operator's body.